华三H3C交换机配置NTP时钟步骤 示例

现场1台H3C 5110交换机
版本：Comware Software, Version 5.20.99, Release 1105

当前没有指定NTP，

<H3C-5110>dis ntp-service status Clock status: unsynchronizedClock stratum: 16Reference clock ID: noneNominal frequency: 100.0000 HzActual frequency: 100.0000 HzClock precision: 2^18Clock offset: 0.0000 msRoot delay: 0.00 msRoot dispersion: 0.00 msPeer dispersion: 0.00 msReference time: 00:00:00.000 UTC Jan 1 1900(00000000.00000000)

以下是配置步骤
ntp server： 10.248.1.200

1 进入配置模式

<H3C-5110>sys
System View: return to User View with Ctrl+Z.

2 指定ntp server

[H3C-5110]ntp unicast-server 10.248.1.200 

3 配置完成，查看ntp状态

已经同步成功

[H3C-5110]dis ntp-service status Clock status: synchronizedClock stratum: 4Reference clock ID: 10.248.1.200Nominal frequency: 100.0000 HzActual frequency: 100.0000 HzClock precision: 2^18Clock offset: 0.0000 msRoot delay: 427.93 msRoot dispersion: 0.11 msPeer dispersion: 89.86 msReference time: 03:29:50.598 UTC May 15 2025(EBCFDE2E.99334C5D)

查看当前时间，不对，差了8小时，是因为时区没改，

要改为东8区

[H3C-5110]dis clock
03:29:56 UTC Thu 05/15/2025[H3C-5110]clock timezone UTC add 8:00:00

修改后再次查看日期时间正常

[H3C-5110]dis clock
11:30:18 UTC Thu 05/15/2025
Time Zone : UTC add 08:00:00

---

如果没有NTP SERVER, 想要手工的指定日期时间，使用下面命令

注意：是在>模式，而不是配置模式

clock datetime 21:27:00 2025/5/1 

如果报错，说明需要先指定clock protocl为none
示例：

<H3C-5110>clock datetime 21:27:00 2025/5/1 
To manually set the system time, execute the clock protocol none command first.[H3C-5110]clock protocol none
<H3C-5110>clock datetime 21:27:00 2025/5/1 

确认修改已经生效

[H3C-5110]dis clock
21:27:19.038 UTC Thu 05/01/2025